Osmo Polyx Raw Matt 3044 (2.5L)

SURFACE PREPARATION

Wood surface must be clean, dry and frost-free (moisture content max. 18%).
Osmo Polyx®-Oil Effect Raw is ready to use. Do not thin. Stir well using a flat stirring stick or spatula before use.
Clean old microporous stains thoroughly. Old paints and lacquers must be completely removed. As a general rule, wear a dust mask during sanding works.
Fill small cracks, larger joints or holes in wood (with Osmo Wood Filler).
Sand wood surfaces carefully. Begin with coarse sandpaper – final sanding work for flooring P120-150, for furniture P180-240. Before oiling the surface, remove sanding dust with a soft brush or vacuum cleaner. Applying Polyx®-Oil Effect Raw over very textured or coarse surfaces could appear more white.

The finished surface is influenced by several factors, including the condition of the wood. Therefore, a trial application is always required, especially for unfamiliar surfaces.

METHOD OF APPLICATION

With Osmo Flat Brush, Floor Brush or Osmo Microfibre Roller, apply thinly along the wood grain and spread well. Applying excess Polyx®-Oil Effect Raw 3044 may lead to a white chalky surface. Remove visible white pigments before allowing the surface to dry. Allow to dry for approx. 24 hours under good ventilation.
After drying, quickly apply a second coat also thinly.
When renovating or recoating an already oiled surface, one coat applied to the clean and dry surface is usually sufficient.

NOTE

Polyx®-Oil Effect Raw is slightly white tinted and protects lighter coloured wood species nearly invisibly. On dark, reddish or ‘smoked / fumed’ wood species, Polyx®-Oil Effect Raw is visible as slightly white chalky surface. Applying excess Polyx®-Oil Effect Raw 3044 may also lead to a white chalky surface. Remove visible white pigments before allowing the surface to dry.A trial application is recommended.

Applying the product too generously and insufficient ventilation lead to delays in drying time and the typical smell of oil.
Any brushstrokes can be removed with an unused dry Microfibre Roller within 30 minutes after applying.

For extractive rich hardwoods (e.g. Wenge, Merbau, Jatoba etc.), we recommend using Osmo Wood Wax Finish Clear Extra Thin. A trial application is recommended.
Caution: Apply max. one coat thinly to cabinet interiors and drawers with a cloth.

Using general or multi-purpose cleaners will increase the frequency of maintenance and recoating. Allow finish to fully cure before heavy usage.